Bald Hills wind farm is located in Victoria, Australia. It was finished in 2015 and is owned by Mitsui & Co. (Australia).
It is near 170 SE Melbourne, South Gippsland Shire.
See below for data.
Wind farms, as a general rule require wind speeds of 4.5 metres per second or more.
An ideal destination for a project like Bald Hills might have a near constant flow of non-turbulent wind all year long, having a minimum probability of abrupt potent bursts of wind. Additionally, you wouldn’t get a turbine Mitsui & Co. (Australia) like Mitsui & Co. (Australia) involved if Bald Hills was not built near local demand or transmission capa170 SE Melbourne, South Gippsland Shire.
Before development, Bald Hills was probably screened on the basis of a wind atlas, and validated with wind specifications. However, Bald Hills wind farm would have needed more than just meteorological data and measurements.
Assortment of site-specific data for wind speed and direction would have been crucial to determining site potential to be able to fund the project. Local winds are frequently checked for a year or more, and comprehensive wind maps built before wind generators are set up.
The wind hits more rapidly at greater altitudes as a result of reduced influence of drag. The boost in velocity with altitude is most spectacular near the surface and is impacted by landscape, surface roughness, and upwind obstructions such as trees or buildings. Velocity grows with altitude and is also more obvious near land and is transformed by topography, surface and limitations.
Commonly, the growth of wind speeds with escalating height follows a wind profile power law, which forecasts that wind speed rises proportionately to the seventh root of altitude. Increasing the elevation of a turbine, then, enhances the expected wind speeds by 10%, and the estimated power by 34%.
In general, a range of 7D (7 × Rotor Diameter of the Wind Turbine) is defined between each turbine in a fully developed wind farm. But this may not be the case in hilly areas.
Bald Hills turbines are connected via medium voltage lines and communications.
At a substation, this particular medium-voltage electric current is improved in voltage with a transformer for link with the high voltage transmission system. Construction of a land-based wind farm requires setting up the collector system and substation, and possibly access roads to every turbine site.
Facts about Bald Hills wind farm
- Name: Bald Hills
- Wind turbine Supplier: Enercon, Model: E82_2000kW, Units: 3,
- Country: Australia
- Developer: Mitsui & Co. (Australia)
- State: Victoria
- City: 170 SE Melbourne, South Gippsland Shire
- Owner: Mitsui & Co. (Australia)