Cullerin Range wind project was installed in New South Wales, Australia It was created in 2009 and is owned by Origin Energy.
It is near 12km east of the township of Gunning, 30 km west of Goulburn.
See below for data.
Wind farms, as a general rule demand wind speeds of 4.5 metres per second or higher.
The best location for a project like Cullerin Range could have a near constant flow of non-turbulent wind all year round, having a minimum probability of sudden potent bursts of wind. An important factor of turbine siting is moreover admission to local requirement or transmission capa12km east of the township of Gunning, 30 km west of Goulburn.
Before building, Cullerin Range was almost certainly screened on the foundation of a wind atlas, and validated with wind measurements. Meteorological wind data alone is usually not sufficient for correct siting of a large wind power project.
Site information around 12km east of the township of Gunning, 30 km west of Goulburn would have been a major factor in the ‘development’ final decision Winds around 12km east of the township of Gunning, 30 km west of Goulburn are analysed for over a year or so alongside the creation of detailed maps. Only then are wind turbines installed.
Altitude would also possess a part to performin a project like Cullerin Range. This is because of drag The surge in velocity with altitude is most dramatic close to the surface and is affected by topography, surface roughness, and upwind obstructions such as trees or buildings. Velocity increases with altitude and is also more obvious near land and is altered by landscape, surface and hurdles.
Wind speeds escalating with altitude is part of a wind energy law. This New South Waless wind speed rises with the 7th root of altitude. Increasing the height of a turbine, then, raises the anticipated wind speeds by 10%, and the expected power by 34%.
The distance of 7x Rotor Diameter is placed between each turbine, ie they’re spaced out so they don’t affect one another. But micrositing increases placement, particularly in hilly areas.
Cullerin Range turbines are related via medium voltage lines and communications.
At a substation, that medium-voltage electric energy is increased in voltage using a transformer for connection to the high voltage transmission system. Development of a land-based wind farm requires installation of the collector system and substation, and probably access roads to each turbine site.
Facts about Cullerin Range wind farm
- Name: Cullerin Range
- Wind turbine Supplier: Goldwind, Model: GW87-1.5MW, Units: 23,
- Country: Australia
- State: New South Wales
- City: 12km east of the township of Gunning, 30 km west of Goulburn
- Owner: Origin Energy